Driver name installation guide

← All installation guides

A clean fit for your driver names.

Follow this dry-fitting guide for MRN driver names and flags supplied with application tape. Work through the steps before removing any backing.

What you’ll need

  • Clean microfibre cloth
  • Isopropyl alcohol or a suitable surface cleaner
  • Masking tape for alignment
  • Felt-tipped squeegee, or a card wrapped in a clean soft cloth

1. Clean, position and mark

Thoroughly clean the window to remove oil, grime and dirt. Wipe with a clean microfibre cloth and allow the surface to dry.

Position the name and flag with the backing still attached. Use masking tape as an alignment guide, then check the spacing and position on both sides of the car.

Clean rear side window and driver name aligned with masking tape

2. Peel the backing and place the name

Place the decal face down on a clean, flat surface. Carefully peel the backing paper away, keeping the lettering on the application tape. If a letter stays on the backing, lay it back down, press over it and try again.

Keep the exposed adhesive clean. Hold the ends with both hands, keeping the decal taut without stretching it, and align it with your masking-tape reference before laying it onto the window.

Backing paper peeled from driver name and decal positioned on window

3. Squeegee and remove the application tape

Use overlapping up-and-down strokes with firm, even pressure. Work slowly from one side to the other to press out the air and secure every letter.

Peel the application tape back slowly, keeping it close to the window. If any vinyl lifts, lower the tape, press the area down again and resume carefully. Remove your alignment tape.

Squeegee strokes and finished driver name with Australian flag

4. Check the finish

Check that all letters, the flag and the edges are firmly attached. Step back and compare the positioning on both sides. Take a photo of your finished car and tag MRN on your socials.