Windscreen banner & wet installation guide

← All installation guides

More time to line it up.

A step-by-step wet-application guide for MRN graphics confirmed as suitable for wet fitting, including suitable windscreen banners.

What you’ll need

  • Clean spray bottle
  • 500 mL water, 3 drops of baby shampoo and 5–10 drops of isopropyl alcohol
  • Clean microfibre cloth and suitable surface cleaner
  • Masking tape for alignment
  • Felt-tipped squeegee

1. Prepare your slip solution

In a clean spray bottle, mix 500 mL of water with 3 drops of baby shampoo and 5–10 drops of isopropyl alcohol. Mix thoroughly.

Wet-fitting solution of water, baby shampoo and isopropyl alcohol

2. Clean the fitting area

Work away from direct sunlight in a cool, clean environment. Thoroughly clean the panel or glass to remove oil, grime and dirt using isopropyl alcohol or a suitable surface cleaner and a clean microfibre cloth.

3. Position and mark reference points

With the backing still attached, temporarily position the graphic using masking tape. Check the alignment and mark reference points along the top, bottom and sides with separate pieces of tape.

For a windscreen banner, check the view from the driver’s seat and the applicable placement requirements before fitting. Retain your reference markers when you lift the graphic away.

Temporary positioning tape and separate alignment markers around a banner

4. Peel, spray and position

Place the graphic face down on a clean, flat surface. Carefully peel off the backing paper without contaminating the adhesive.

Generously spray both the exposed adhesive and the fitting surface with the slip solution. Hold the graphic with both hands, align it with your reference markers and gently lay it into position.

Backing removed and slip solution sprayed onto the adhesive

5. Squeegee from the centre outwards

Hold your felt-tipped squeegee at approximately 45°. Use firm, consistent pressure and overlapping strokes to push the liquid out from the centre towards one edge, then work from the centre towards the opposite edge.

Work smoothly across the whole graphic. If you miss an area, start again from the centre.

Squeegee strokes push liquid from the centre towards both ends of the graphic

6. Remove the application tape, if supplied

The printed MRN guide uses approximately 30 minutes as an initial waiting period. Check a small edge first: the vinyl must stay attached when the tape is lifted. Allow longer if needed.

If the supplied application tape is paper, lightly wetting it with the slip solution can help it release. Peel the tape back slowly at roughly 45°. If the graphic lifts, lower the tape, squeegee the area again and allow more time before retrying.

Application tape carefully peeled from the installed graphic

7. Check the finish

Check the position and all edges before removing your alignment markers. If you have a matching graphic for the other side, measure its position for a symmetrical result. Contact MRN if you’re unsure about the finish or aftercare for your material.